skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing camshaft for engine with engine identification characters BMM > < Inspect axial play of the camshaft for engine with engine identification characters BMM

Octavia Mk2

Replace gasket ring of camshaft for engine with engine identification characters BMM
Replace gasket ring of camshaft for engine with engine identification characters BMM
Special tools and workshop equipment required
t  Insertion tool -MP 1-214 (10-203)-
t  Gasket ring extractor -T30003 (3240)-
t  Counterholder -T10051-
t  Extractor -T10052-
t  Screw M12 x 65
Removing
l  Cylinder head attached at engine.
–  Removing toothed belt → Chapter.
–  Remove the locking pin - 3359-.
   
–  Unscrew the screws of the toothed belt sprocket -arrows- and remove the toothed belt sprocket from the hub.
  S13-0448
–  Loosen fixing bolt of the hub -1- approx. 2 turns, to do so use the counterholder -T10051-.
  S15-0307
–  Position the extractor -T10052- and screw the screws -1- into the hub.
–  Pull off the hub, to do so counterhold the hexagonal wrench (SW 30) of the extractor and screw in the screw -2-.
–  Set the inner part of the sealing ring extractor -T30003- flush with the outer part and interlock with the knurled screw.
  S15-0308
–  Oil the thread head of the gasket ring extractor, position and forcely screw into the gasket ring of the camshaft as far as possible.
–  Release knurled screw and turn the inner side against the camshaft until the gasket ring is pulled out.
–  Clamp gasket ring extractor into the vice and remove gasket ring with pliers.
–  Clean the contact and sealing surface.
Installing
Installation occurs in reverse order to removal. Pay attention to the following:
  Note
Sealing lip of the gasket ring must not be oiled or greased additionally.
–  Remove oil residue from the camshaft stud with a clean cloth.
–  Cover slot on the camshaft cone with adhesive tape and carefully push the sealing ring onto the camshaft.
  S15-0169
–  Press in the gasket ring with the pressure plate of the insertion tool -MP 1-214- and the screw M12 x 65 up to the stop.
–  Position hub onto camshaft.
  S15-0170
–  Tighten screw -1- to 100 Nm, use counterholder -T10051- to counterhold.
  S15-0307
–  Push the toothed belt sprocket of the camshaft onto the hub.
l  The tooth segment -arrow- of the toothed belt sprocket must be at the top.
–  Slightly screw in plug -1-.
–  Interlock hub with locking pin, e. g. -3359-.
–  install (set the timing) → Chapter.
  S15-0371

Removing and installing camshaft for engine with engine identification characters BMM > < Inspect axial play of the camshaft for engine with engine identification characters BMM