Octavia Mk2
Note
|
1 - | Bearing shell |
q | for cylinder block with lubricating groove |
q | do not mix up used bearing shells (mark) |
2 - | Drive chain sprocket |
q | for oil pump |
q | removing and installing → Chapter |
3 - | Bearing shell |
q | for bearing cap without lubricating groove |
q | do not mix up used bearing shells (mark) |
4 - | Thrust washers |
q | for bearing 3 |
q | different version for cylinder block and bearing cap |
q | pay attention to locating element |
5 - | 65 Nm + torque a further 90° (1/4 turn) |
q | replace |
6 - | Bearing caps |
q | Bearing cap 1: belt pulley side |
q | bearing cap 3 with recesses for thrust washers |
q | retaining lugs of the bearing shells of the cylinder block/bearing cap must be on top of one another |
7 - | Needle bearing |
q | only vehicles with automatic gearbox |
q | replace → Chapter |
8 - | Crankshaft |
q | with chain sprocket for oil pump drive |
q | Axial play when new: 0.07...0.17 mm; Wear limit: 0.37 mm |
q | Crankshaft bearing pins: Ø 54.00 mm |
q | Conrod bearing: Ø 50.90 mm |