skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Engine control unit > < Replacing O-rings of unit injector for engine with engine identification characters BMM

Octavia Mk2

Removing and installing engine speed senderG28
Removing and installing engine speed sender -G28-
Special tools and workshop equipment required
t  Hose clamps up to Ø 25 mm -MP7-602 (3094)-
t  Assembly tool -T10118-
Removing
–  Remove noise insulation → Body Work → Rep. Gr.50.
–  Press together the coolant hoses at the oil cooler with one hose clamp each and remove the coolant hoses.
–  Remove the oil filter holder → Chapter.
   
–  Remove the plug -arrow- on the engine speed sender -G28- with the assembly tool -T10118- and expose the electrical line.
  Note
To unlock the plug without using the assembly tool -T10118-, the unlock button must be pressed at the plug using the screwdriver and at the same time raise the unlock button with a thin wire hook.
  A23-0205
–  Unscrew the fixing screw -2- of the engine speed sender -G28--1-.
Install
Installation occurs in reverse order to removal. Pay attention to the following:
–  Install the oil filter holder → Chapter.
Tightening torque
  A23-0209
ComponentNm
Engine speed sender -G28- on the flange5

   

Engine control unit > < Replacing O-rings of unit injector for engine with engine identification characters BMM