skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing the left temperature flap control motorV158 > < Remove and install control motor of air flow flapV71 or control motor of air flow flap and re-circulating air flapV71

Octavia Mk2

Removing and installing the defroster flap control motorV107
Removing and installing the defroster flap control motor -V107-
Removing
–  Remove the dash panel → Body Work → Rep. gr.70.
–  Remove left footwell vent.
–  Remove the control unit for data bus diagnostic interface -J533- (attached in the area of the steering column to the bracket) → Electrical System → Rep. gr.90.
–  Remove holder on the left of the air conditioning unit → Chapter.
   
–  Disconnect the plug connection at the defroster flap control motor -V107--2-.
–  Unscrew fixing screws -1-, remove defroster flap control motor -V107--2- and unhook strut.
Install
Installation is carried out in the reverse order.
  Note
t  After installing the control motor, it is necessary to test the operation of the defroster flap.
t  Carry out the function „Initiate basic setting“ with the Vehicle diagnosis, measurement and information system -VAS 5051-.
  S87-0243

Removing and installing the left temperature flap control motorV158 > < Remove and install control motor of air flow flapV71 or control motor of air flow flap and re-circulating air flapV71