Skoda Workshop Service and Repair Manuals > Octavia Mk2 > Heating, ventilation, air conditioning system | Heating, Air conditioning | Aux. heater/heater booster | Disassembling and assembling auxiliary heating | Removing and installing, checking the temperature sensorG18 and the overheating sensorG189

Removing and installing, checking the temperature sensorG18 and the overheating sensorG189

Removing and installing, checking the temperature sensor -G18- and the overheating sensor -G189-

Note

Proper functioning can be checked using the → Vehicle diagnostic tester in the function „Targeted fault finding“.

Removing

–	Release screw -1- and remove retaining spring -2-.

–	Pull out temperature sensor -G18--3- and overheating sensor -G189--4- using a set of pointed pliers.

Install

Installation is performed in the reverse order, pay attention to the following points:

Note

t	Pay attention to the correct location of the retaining spring -2-.

t	The sensors cannot be replaced individually.

Skoda Workshop Service and Repair Manuals