skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Fuel supply of auxiliary heating > < Removing and installing glow plug with flame monitoringQ8 on Thermo Top V

Octavia Mk2

Removing and installing glow plug with flame monitoringQ8 on Thermo Top VEVO
Removing and installing glow plug with flame monitoring -Q8- on Thermo Top VEVO
Removing
–  Remove housing with combustion air blower -V6- → Chapter.
   
–  Pull out retaining spring -1--arrow-.
–  Remove retaining bracket -2-.
–  Remove glow plug with flame monitoring -Q8- Pos. -3-.
Install
Installation is performed in the reverse order, pay attention to the following points:
  Note
  N82-10500
t  Observe the fitting position of the retaining spring -1- as well as the retaining bracket -2-.
t  The non-insulated connecting lines to the glow plug must not touch or rest against any other components (risk of short circuit).
t  Proper functioning of the glow plug with flame monitoring -Q8- can be checked using the → Vehicle diagnostic tester in the function „Targeted fault finding“.
  N82-10500

Fuel supply of auxiliary heating > < Removing and installing glow plug with flame monitoringQ8 on Thermo Top V