skoda Workshop Repair Guides

Skoda Octavia Workshop Service and Repair Manuals

ABOUT US
Aux. heater/heater booster > < Removing and installing intake air grid

Removing and Installing Control Unit for Temperature Flap - Octavia Mk2

Removing and installing the control unit for temperature flap
Removing and installing the control unit for temperature flap
Removing
–  Remove the side cover on the driver's side → Body Work → Rep. gr.68.
–  Remove left footwell vent → Chapter.
   
–  Unclip the control cable at the positioning unit for temperature flap -2-.
–  Release the catch -1- and press the control unit for temperature flap in -the direction of the arrow- up to the stop.
–  Pull off positioning unit for temperature flap.
Install
Installation is carried out in the reverse order.
  Note
After installing, it is necessary to test the operation of the temperature flap. It must be possible to adjust the rotary knob from the position „cold“ into position „warm“ in a smooth and easy way.
  S80-0142

Aux. heater/heater booster > < Removing and installing intake air grid