skoda Workshop Repair Guides

Skoda Workshop Manuals

< PREV PAGE NEXT PAGE >
Summary of components
   
Summary of components
1 - Dash panel
q   removing and installing → Body Work → Rep. gr.70
2 - Centre vent
q   removing and installing → Chapter
3 - Outer dash panel vent
q   removing and installing → Chapter
4 - Re-circulating air flap control motor -V113-
q   removing and installing → Chapter
5 - Right footwell vent
q   removing and installing → Chapter
6 - Flex shaft
q   for positioning unit for air distribution flaps
q   removing and installing → Chapter
7 - Series resistor for fresh air blower with overheating fuse -N24-
q   removing and installing → Chapter
8 - Fresh air blower -V2-
q   removing and installing → Chapter
9 - Shield for heater unit
q   removing and installing → Fig.
10 - Dust and pollen filter
q   removing and installing → Chapter
11 - Rear duct of right footwell
q   removing and installing → Chapter
12 - Center rear duct
q   removing and installing → Body Work → Rep. gr.68
13 - Center rear vent
q   removing and installing → Chapter
14 - Air deflector
q   for center rear vent
15 - Rear duct of left footwell
q   removing and installing → Chapter
16 - Screws, 1.5 Nm
q   8 pieces
17 - Heater control
q   removing and installing → Chapter
18 - Adapter for heater control
19 - Heating element for air auxiliary heating -Z35-
q   removing and installing → Chapter
20 - Heat exchanger
q   removing and installing → Chapter
q   replace coolant after changing the heat exchanger
21 - Left footwell vent
q   removing and installing → Chapter
22 - Bowden wire for temperature flap
q   removing and installing → Chapter
23 - Heating
q   removing and installing → Chapter
q   disassembling and assembling → Chapter
24 - Intermediate piece for defroster duct
q   placed onto the distributor housing and secured with a clip on the cross member - dash panel
q   for removing, take out dash panel
25 - Intermediate piece for dash panel vents
q   placed onto the distributor housing
q   for removing, take out dash panel
26 - Vent duct
q   for window blower in the door
q   Part of the cover

   
Remove shield for heater unit
–  Unscrew the plastic screws -2- and remove the shield -1-.
  S80-0117
Fitting position of the seal for heater unit/engine compartment
–  First of all insert seal for heater unit/engine compartment -1- into the bulkhead -2- and then pull the sealing lip -3- into the groove of the heat exchanger.
  Note
In order to prevent water leaking into the interior of the vehicle, pay attention to the fitting position.
  S80-0118

Heating, ventilation, air conditioning system > Heating, Air conditioning > Heating > Repairing the heating > Summary of components

< PREV PAGE NEXT PAGE >