Octavia Mk2
| Summary of components |
Note| t | If parts of the clutch slipped out or the plate supports were raised, then the large - and if necessary also the small - plate support can be inserted by hand with slight rotary movement into all interior plates. |
| t | In particular the clutch cover must always be installed in the same position, as it was the case when delivering the »new« clutch → Chapter. |
| 1 - | Circlip |
| q | Determine new thickness → Chapter |
| 2 - | Large plate support |
| q | do not remove |
Caution
|
| 3 - | Housing of the double clutch |
| q | with mounted clutch „K2“ |
| 4 - | Sealing ring |
| q | 4 pieces |
| 5 - | Outer plate |
| q | 4 pieces |
| 6 - | Inner plate |
| q | 4 pieces |
| 7 - | Thrust washer |
| 8 - | Circlip |
| q | if the circlip was removed in order to newly insert the plates, it is replaced by a new ring with the same thickness |
| 9 - | Clutch cover |
| 10 - | Circlip |
| q | always replace → Electronic Catalogue of Original Parts |
| q | do not install corrugated circlips |
