skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing rear final drive (Octavia II, Superb II) > < Removing and installing the rear final drive

Octavia Mk2

Summary of components - Rear final drive
   
Summary of components - Rear final drive
  Note
-Arrow- points in direction of travel.
1 - Rear assembly carrier
2 - Drive shaft
q   removing and installing → Chassis; Rep. gr.42
3 - Rear final drive
q   removing and installing:
t  Octavia II, Superb II → Chapter
t  Yeti → Chapter
q   Replace the rubber-metal bearing → Chapter
4 - Stop washer
q   mount onto the rubber-metal bearing → Fig.
5 - Screw
q   3 pieces
q   Tightening torque → Chassis; Rep. gr.42
q   Assignment → Electronic Catalogue of Original Parts
6 - Propshaft
q   removing and installing:
t  Octavia II, Superb II → Chapter
t  Yeti → Chapter
7 - Washer
q   installed between final drive and assembly carrier → Fig.
q   on certain vehicles 2 washers can also be present
q   Re-install the same number of washers
8 - Stop washer
q   mount onto the rubber-metal bearing → Fig.

   
Fitting position of the rubber-metal bearings „rear top“ and „front bottom“. Fitting of the stop washer -B-
l  Final drive in fitting position
Fitting position of the rubber-metal bearings „rear top“ and „front bottom“:
t  The rubber-metal bearings „rear top“ point with the stud -A- to the top
t  The rubber-metal bearing „front bottom“ points with the stud -A- to the bottom
Fitting of the stop washer -B-
–  Insert the pegs -A- in the holes of the stop washer -arrows-.
The stop washer -B- is then connected captively with the rubber-metal bearing.
  N34-10742

Removing and installing rear final drive (Octavia II, Superb II) > < Removing and installing the rear final drive