skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing propshaft > < Removing

Octavia Mk2

Install
Install
Installation is performed in the reverse order, pay attention to the following points:
   
–  Moisten gasket ring -A- with gear oil.
–  Insert new gasket ring -A- into the slot -arrow-.
–  Install assembly device -T10047- → Anchor.
  N39-10211
–  In order to avoid damaging the contact surface of the needle bearing on the shaft, turn the shaft during the pressing procedure -arrow-.
–  Secure bearing with new circlip → Electronic Catalogue of Original Parts.
–  Carefully drive in flange shaft (slowly turn flange shaft).
–  On vehicles with particle filter install the bracket for the particle filter, if it was removed → Engine; Rep. gr.26.
–  Secure the flange shaft with a new conical screw and tighten to tightening torque with socket insert -T10107 A-.
–  Install right drive shaft → Chassis; Rep. gr.40.
  S39-0122
–  Install cap for drive shaft -arrows-, if it was removed.
–  Inspecting oil level in the angle gearbox → Chapter.
–  Install the front right wheelhouse liner → Body Work; Rep. gr.66.
–  Install the noise insulation → Body Work; Rep. gr.50.
–  Install right wheel → Chassis; Rep. gr.44.
  A39-0277
Tightening torques
ComponentNm
Flange shaft on gearbox (conical screw)1)Octavia II → Chapter
Superb II → Chapter
Yeti → Chapter
Protective cap drive shaft on angle gearboxOctavia II, Superb II → Chapter
Yeti → Chapter

1) Always replace screw → Electronic Catalogue of Original Parts.
   

Removing and installing propshaft > < Removing