Skoda Workshop Service and Repair Manuals

Install

–  Push drive shaft -A- of gearbox oil pump up to the stop into the gearbox. Turn the drive shaft slightly. –  Replace gasket for gearbox oil pump -B- at gearbox → Electronic Catalogue of Original Parts. l  Both dowel pins -C- must be located in the gearbox housing.   Note

Pay attention to the installed dimension of the shaft -A- = approx. 23 mm. –  If necessary carefully remove metallic swarf on the rotor -B-, the rotor must not be demagnetized. –  Remove the gasket between the gearbox oil pump and the gearbox. –  Clean the sealing surfaces for the gearbox oil pump and the gearbox. –  Fit new gasket between the gearbox oil pump and the gearbox, if necessary fix with gearbox oil.

–  Push the gearbox oil pump -1- onto the drive shaft, pay attention to the serration of the oil pump/drive shaft. –  Also pay attention to the correct seating of the gearbox oil pump -1- on the dowel pins of the gearbox housing.   Note Pay attention to different screws for the gearbox oil pump and tightening process. Different screws for the gearbox oil pump and tightening process

All 4 flat head screws -arrows-: t  Tightening torque 5 Nm + torque a further 90° (1/4 turn)

3 flat head screws (bottom), 1 sountersunk screw (top) -arrow-: t  3 flat head screws (bottom): tightening torque 8 Nm + torque a further 90° (1/4 turn) t  1 sountersunk screw (top) -arrow-: tightening torque 8 Nm –  Screw in new screws and then tighten crosswise to the corresponding tightening torque.

–  Fit new cover for gearbox oil pump -A- and tighten the new screws -arrows- in successive stages to tightening torque → Chapter. –  Replace gearbox oil filter (instructions, when the gearbox oil filter must be replaced and when not → Chapter). –  Pour in gear oil → Chapter. –  Install the complete cover of the left wheelhouse liner. –  Install the front left wheelhouse liner → Body Work; Rep. gr.66. –  Install the noise insulation → Body Work; Rep. gr.50.