Octavia Mk2
Summary of components - Repairing the clutch make „Sachs“ |
Note
t | Before replacing the clutch disc and pressure plate fault finding power transmission - observe complaints of the clutch and clutch control → Chapter. |
t | Replace the clutch discs and pressure plates if the riveting is damaged or loose. |
t | Assign the clutch disc and pressure plate in accordance with engine identification characters → Electronic Catalogue of Original Parts. |
t | The two-mass flywheel, pressure plate and clutch disc are assigned to each other and must not be installed together with components from other manufacturers. |
1 - | The two-mass flywheel |
q | make sure the centering pins are tight |
q | The locating face for the clutch lining must be free from grooves, oil and grease |
q | Observe removal instructions for two-mass flywheel → Engine; Rep. gr.13. |
q | Removing and Installing → Engine; Rep. gr.13 |
2 - | Clutch disc |
q | Assign the diameter via the → Electronic catalogue of original parts. |
q | removing and installing → Chapter |
q | must only be replaced together with pressure plate |
q | Fitting position → Fig. |
3 - | Pressure plate |
q | Assignment → Electronic Catalogue of Original Parts |
q | with resetting mechanism |
q | Distinguishing feature → Fig. |
q | removing and installing → Chapter |
q | Check the extremities of the membrane springs → Fig. |
q | Check feather joints and riveted joints → Fig. |
q | must only be replaced together with clutch disc Pos. 2 |
4 - | Screw M6-13 Nm; screw M7-20 Nm |
q | Assignment → Electronic Catalogue of Original Parts |
q | release or tighten in small stages crosswise |