skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Check oil level in the Haldex coupling or change oil or top up with oil > < Replacing grooved ball bearing for Haldex coupling (final drive "02D/0AV") (Octavia II)|Install

Octavia Mk2

Removing and installing oil filter for Haldex coupling (final drive „02D/0AV“) (Octavia II)
Removing and installing oil filter for Haldex coupling (final drive „02D/0AV“) (Octavia II)
Special tools and workshop equipment required
t  Catch pan
  Note
On vehicles with the rear final drive „OBR“, the oil filter for the Haldex coupling is not replaced.
   
Removing
–  Place a catch pan under the rear final drive.
–  Unscrew cap -arrow-.
–  Pull out oil filter unit.
  A39-10225
Install
Installation is performed in the reverse order, pay attention to the following points:
–  Install O-ring -2- onto the oil filter carrier -1-.
–  Insert connecting spring -4- into the oil filter -3-.
  A39-10226
–  Screw in screw cap -arrow- with a new O-ring and tighten to tightening torque → Item.
–  Check oil level in the Haldex coupling → Chapter
  A39-10225

Check oil level in the Haldex coupling or change oil or top up with oil > < Replacing grooved ball bearing for Haldex coupling (final drive "02D/0AV") (Octavia II)|Install