skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing the pump for Haldex coupling (final drive "0BR")|Install > < Removing and installing the pump for Haldex coupling (final drive "0BR")

Octavia Mk2

Removing
Removing
–  Switch off ignition.
–  Place catch pan under the final drive.
   
–  Unscrew screw -B- for oil inspection.
–  Unscrew oil drain plug -A- and completely drain high efficiency oil for Haldex coupling.
–  Screw in new oil drain plug -A- and tighten to the prescribed tightening torque.
  S39-0362
–  Slightly lower the final drive, to do so the fixing screw -arrow- must be released by approx. 5 turns at the front bracket of the final drive.
  S39-0329
–  Disconnect plug -arrow- for the pump from the control unit.
  S39-0367
–  Unclip the wiring loom -A- from the holders -arrows- and expose.
  S39-0407
–  Screw out the fixing screws -1- of the pump for Haldex coupling -V181--2-.
–  Pull the pump for Haldex coupling -V181- out of the housing for the Haldex coupling in -direction of arrow-, to do so guide through the wiring loom -3-.
  S39-0406

Removing and installing the pump for Haldex coupling (final drive "0BR")|Install > < Removing and installing the pump for Haldex coupling (final drive "0BR")