Skoda Workshop Service and Repair Manuals

Install –  The installation occurs in reverse order, while paying attention to the following.

–  Moisten gasket ring -2- with gear oil. –  Insert gasket ring -A- into the slot -arrow-. –  Install assembly device -T10047- → Anchor.

–  In order to avoid damaging the contact surface of the needle bearing on the shaft, turn the shaft during the pressing procedure -arrow-. –  Secure bearing with new circlip → Electronic Catalogue of Original Parts. –  Carefully drive in flange shaft (slowly turn flange shaft).

–  Tighten the screw of the flange shaft -arrow 1- with socket insert -T10107A-. –  After installing the right flange shaft, check the oil level in the angle gearbox → Chapter, to do so unscrew the oil filler plug -B-. –  Install right drive shaft → Chassis; Rep. gr.40. –  On vehicles with particle filter install the bracket for the particle filter, if it was removed → Engine; Rep. gr.26.

–  Install heat shield for drive shaft -arrows-, if it was removed.

Vehicles with auxiliary heating. –  On these vehicles, fit the coolant pipes -B- onto the double screws at the angle gearbox and install on the engine -arrow 2-. For all vehicles –  Install the front right wheelhouse liner → Body Work; Rep. gr.66. –  Install the noise insulation → Body Work; Rep. gr.50. –  Attach the right front wheel → Chassis; Rep. gr.44.

Tightening torques

Component	Nm
Flange shaft on gearbox (conical screw)	→ Chapter
Heat shield of drive shaft to angle gearbox	→ Chapter