Skoda Workshop Service and Repair Manuals

Repairing clutch housing Special tools and workshop equipment required t  Pressure spindle -MP3-423 (VW 407)- t  Drift -T10168- t  Thrust piece -T40008- t  Interior extractor, e.g. -Kukko 21/2- t  Interior extractor, e.g. -Kukko 21/4- t  Countersupport e.g. -Kukko 22/1- t  Countersupport e.g. -Kukko 22/2-

Remove bushing for gear shift rod A -  Countersupport, e.g. -Kukko 22/1- B -  Interior extractor 14.5...18.5 mm, e.g. -Kukko 21/2-   Note After removing the bushing check for damage, if necessary replace.

Drive in the bushing for the shift rod up to the stop of the tool

Removing needle bushing from clutch housing A -  Countersupport, e.g. -Kukko 22/2- B -  Interior extractor 23.5...30 mm, e.g. -Kukko 21/4-   Note The needle bushing is damaged when removed and must be replaced.

Pressing in needle bushing -A- in the clutch housing –  During press-in procedure, position the thrust washer -B- of the reverse shaft onto the needle bushing -A-.

Removing gasket ring for drive shaft –  Carefully lever out gasket ring with a screwdriver.   Note t  Do not damage contact surface for shaft seal on the drive shaft. t  The gasket ring can also be removed with the extraction hook -T20143/1-.

Insert the gasket ring for the drive shaft until flush

Press shaft for reverse gear shift fork into the clutch housing