skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Summary of components - Gearshift mechanism (Octavia II as of 11.06) > < Removing and installing gearshift knob and cover (Octavia II)

Octavia Mk2

Summary of components - Gearshift mechanism (Octavia II up to 10.06)
   
Summary of components - Gearshift mechanism (Octavia II up to 10.06)
  Note
Grease bearing and friction surfaces with grease -G 000 450 02-.
1 - Lock washer
q   removing and installing → Fig.
2 - Bushing
3 - Spring
4 - Bushing
5 - 5 Nm
6 - Cover
7 - Damping
8 - Damping
9 - Bearing shell
10 - Shift lever guide
11 - Insulating washer
12 - Gasket
q   between shift housing and underbody
q   self-adhesive
q   stick onto shift housing
13 - Shift lever
14 - Shift housing
15 - Bushing
16 - Bearing bolt
17 - Guide bushing
18 - Spring
q   installing → Fig.
19 - Selector angle plate
20 - 5 Nm
21 - Gasket
q   always replace → Electronic Catalogue of Original Parts
22 - Floor plate
q   bend up tabs for removing
q   always replace → Electronic Catalogue of Original Parts
23 - Selector cable
q   removing and installing → Chapter
q   detaching and attaching at selector angle plate → Fig.
24 - Shift cable
q   removing and installing → Chapter
q   remove from the shift lever guide pos. 10 → Fig.
25 - Lock washer
q   always replace → Electronic Catalogue of Original Parts
26 - 8 Nm
q   4 pieces
27 - Bushing
q   fits in one position only
28 - Lock washer
q   always replace → Electronic Catalogue of Original Parts

   
Detaching and attaching selector cable and shift cable
–  Remove lock washer from shift cable -A- and selector cable -B-.
To do so lift the tab with a screwdriver -arrow 1- and press off lock washer -arrow 2-.
–  Remove shift cable -A- from the support of the gearshift lever.
–  Remove selector cable -B- from the support of the selector angle plate.
  N34-1367
Removing and installing lock washer
–  To remove and install the circlip -arrow A- press bushing -arrow B- with a screwdriver up to the stop in the direction of the arrow -arrow C- and remove circlip.
  Note
t  Do not twist bushing when pressing down.
t  Mounting slot in shift lever for lock washer must be visible.
t  Release spring carefully.
  N34-1363
Install pressure spring
–  Insert the clamp -A- of the pressure spring from the top into the guide -1-.
–  Press the clamp -B- of the pressure spring downwards and insert from the bottom into the guide.
  Note
The illustration shows without the removed selector angle plate.
  S34-0973

Summary of components - Gearshift mechanism (Octavia II as of 11.06) > < Removing and installing gearshift knob and cover (Octavia II)