skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

Refilling oil in Haldex coupling > < Check oil level in the Haldex coupling
Changing oil in the Haldex coupling
Changing oil in the Haldex coupling
Special tools and workshop equipment required
t  Filling device -VAS 6291-
t  Catch pan
Oil specification → Chapter
–  Raise vehicle.
–  For changing use the filling device (e. g. -VAS 6291-). -VAS 6291-).
–  Place the catch pan under the vehicle.
Vehicle with aluminium assembly carrier
  Note
   
t  Always place a cloth on the cross member -arrows-.
t  If the oil gets onto the cross member or into the recesses at the cross member, the oil must be removed immediately.
t  The cross member is not fitted on vehicles with steel assembly carrier.
Continued for all vehicles
  S39-0320
–  Release screw for oil inspection -B-. (shown on a removed final drive for purposes of clear presentation).
–  Screw out oil drain plug -A-.
–  Drain oil.
–  Screw in drain plug -A- using a new sealing ring and tighten to tightening torque.
  S39-0362
–  Screw in adapter -A- up to the stop into the inspection hole.
–  Lock angular piece -B- with adapter.
–  Pull hose above the drive shaft.
The hose must not sag. It must come out above the left rear wheel.
–  Lower the vehicle.
  S39-0322
–  Ensure that the the valve -arrow- is closed.
–  Screw oil reservoir -A- onto filling device -VAS 6291-.
–  Open valve -arrow- and hold oil reservoir as shown.
The Haldex coupilng is now filled with oil.
–  Raise the vehicle after several minutes.
  Note
  S39-0323
t  If the Haldex coupling is correctly filled, oil flows out at the adapter -A-.
t  If no oil flows out, lower the vehicle and continue the filling procedure.
–  Raise vehicle.
–  If oil flows out, place oil reservoir downwards below the level of the Haldex coupling (e.g. on a tool car).
The excessive oil now flows back into the oil reservoir.
–  If no more oil flows back, remove filling device -VAS 6291-.
–  Check oil level in the Haldex coupling.
  S39-0322
–  Screw in screw -arrow- using a new sealing ring and tighten to tightening torque.
  S39-0321
Tightening torque
ComponentNm
Oil check screw1)15
Drain plug130

1) Using a new sealing ring → Electronic Catalogue of Original Parts.
   

Refilling oil in Haldex coupling > < Check oil level in the Haldex coupling