skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing the pump for Haldex coupling (final drive "02D/0AV")|Install > < Removing and installing the pump for Haldex coupling (final drive "02D/0AV")

Octavia Mk2

Removing
Removing
–  Switch off ignition.
–  Place a catch pan under the final drive.
   
–  Release check screw -B-.
–  Unscrew drain plug -A- and completely drain high efficiency oil for Haldex coupling.
–  Screw in drain plug -A- using a new sealing ring and tighten to 30 Nm.
  S39-0362
–  Slightly lower final drive, to do so the fixing screw must be released approx. 7 times at the front bracket-final drive.
  S39-0329
–  Disconnect plug -arrow- for the pump from the control unit.
  S39-0367
–  Pull out wiring loom together with the holder -A- from the housing and expose.
–  Compress catch pegs -B- and push as far as possible into the housing hole.
  S39-0364
–  Screw out the fixing screws of the pump -1-.
–  Pull pump -arrow- together with cable protection -2- out of the Haldex housing.
  S39-0363

Removing and installing the pump for Haldex coupling (final drive "02D/0AV")|Install > < Removing and installing the pump for Haldex coupling (final drive "02D/0AV")