Skoda Workshop Service and Repair Manuals

Install

–  Press in new grooved ball bearing up to the stop.

–  Insert circlip -1-. –  Heat up grooved ball bearing -2- e.g. with hot-air blower to approx. 80°C.

–  Centre the axial needle bearing -5…7- onto the plate clutch -1-. –  Place the housing for the Haldex coupling onto the plate clutch -1- by hand.   Note The axial needle bearings -5…7- must not change their centered position when placing on the housing.

–  Slightly oil new gasket ring before installing on the outside diameter and between the sealing lips with high efficiency oil for Haldex coupling. –  Drive in new gasket ring with pressure plate -T10019- up to the stop. Do not tilt the gasket ring during this process.

–  Press on flange for propshaft.

–  Insert new hexagon nut with locking agent -D 000 600- and tighten. Tightening torque (final drive „02D/0AV“ → Chapter and final drive „OBR“ → Chapter. A -  Screws M10 x 20 B -  Allen screw M8 x 15 (is screwed into the counterholder -T30004 (3415)- from the reverse side) –  Install Haldex coupling → Chapter. –  Install propshaft at rear final drive → Chapter. –  Install exhaust system and align free of stress → Engine; Rep. gr.26. –  Fill up with high efficiency oil for Haldex coupling and check oil level in the Haldex coupling → Chapter.

Tightening torques

Component	Nm
Flexible disk to propshaft	→ Chapter
Propshaft to rear final drive	→ Chapter
Haldex coupling to rear final drive	→ Chapter

1) Using a new sealing ring → Electronic Catalogue of Original Parts.