Octavia Mk2
| Summary of components - Removing and installing the rear final drive „02D/0AV“ |
Note| -Arrow- points in direction of travel. |
| 1 - | Rear assembly carrier |
| 2 - | Snap nut |
| q | 4 pieces |
| q | Tightening torque → Chassis; Rep. gr.42 |
| q | Assignment → Electronic Catalogue of Original Parts |
| 3 - | Screw |
| q | 4 pieces |
| q | for cross member Pos. 4 at assembly carrier Pos. 1 |
| q | Assignment → Electronic Catalogue of Original Parts |
| 4 - | Cross member |
| q | is not applicable for the steel assembly carrier |
| q | Assignment → Electronic Catalogue of Original Parts |
| 5 - | Screw |
| q | Tightening torque → Chassis; Rep. gr.42 |
| q | for drive shaft to rear final drive |
| 6 - | Drive shaft |
| q | removing and installing → Chassis; Rep. gr.42 |
| 7 - | Rear final drive |
| q | removing and installing → Chapter |
| q | Replace the rubber-metal bearing → Chapter |
| 8 - | Stop washer |
| q | mount onto the rubber-metal bearing → Fig. |
| 9 - | Screw |
| q | 3 pieces |
| q | Tightening torque → Chassis; Rep. gr.42 |
| q | Assignment → Electronic Catalogue of Original Parts |
| 10 - | Shim |
| q | installed between final drive and assembly carrier |
| q | Fitting position: Chamfer (smaller Ø) points towards the assembly carrier |
| 11 - | Stop washer |
| q | mount onto the rubber-metal bearing → Fig. |
| 12 - | Support |
