skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Replacing the left flange shaft gasket ring (four-wheel drive) > < Removing

Octavia Mk2

Install
Install
   
–  Pressing on together bushing and gasket ring.
A - Screw threaded rod from assembly device -MP3-434 (3066)- into the threaded part of the differential gear.
B - Nut M12 with washer
–  By turning the nut -B- install the bushing over the pressure plate -T10148- up to the stop.
–  Fill half the space between the sealing lip and dust lip with sealing grease -G 052 128 A1-.
–  Insert the flange shaft.
–  Secure the flange shaft with the conical screw and tighten with tightening torque.
–  Bolt drive shaft to flange shaft → Chassis; Rep. gr.40.
  N39-1188
–  If necessary screw on cap for drive shaft.
–  Check gear oil level → Chapter.
–  Install the noise insulation → Body Work; Rep. gr.50.
  S39-0282
Tightening torque
Flange shaft on gearbox (conical screw) → Chapter
Protective cap of drive shaft on engine (Octavia II) → Chapter
Protective cap of drive shaft on engine (Superb II) → Chapter

   

Replacing the left flange shaft gasket ring (four-wheel drive) > < Removing