Removing and Installing Drive Shaft, Output Shaft, Differential Gear & Shift Forks
| Front-wheel-drive |
| 1 - | Differential gear |
| q | disassembling and assembling → Chapter |
| 2 - | O-ring |
| q | 4 pieces |
| q | always replace → Electronic Catalogue of Original Parts |
| 3 - | Output shaft |
| q | disassembling and assembling → Chapter |
| 4 - | reverse shaft support |
| q | disassembling and assembling → Chapter |
| 5 - | Reverse shaft |
| q | disassembling and assembling ► 08.10 → Chapter |
| q | disassembling and assembling 08.10 ► → Chapter |
| 6 - | Drive shaft |
| q | disassembling and assembling → Chapter |
| 7 - | Gearshift fork reverse gear |
| q | disassembling and assembling → Chapter |
| q | Fitting position → Chapter |
| 8 - | 25 Nm |
| 9 - | Shift mechanism |
| q | (Gearshift forks) |
| q | disassembling and assembling → Chapter |
| 10 - | Clutch housing |
| q | repairing → Chapter |
| 11 - | 25 Nm and torque a further 90° |
| q | 4 nuts for bearing support |
| 12 - | Flange shaft with pressure spring |
| q | removing and installing → Chapter |
| 13 - | 25 Nm |
