skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Control measurement > < Setting drive shaft

Octavia Mk2

Determine the adjusting washer
Determine the adjusting washer
Example:
   
Measured value of bearing playThickness of the adjusting washer according to the table
1.21 mm1.175 mm

   
Adjusting washer table
Bearing clearanceAdjusting washer
Measured value (mm)Thickness (mm)
0,671…0,699
0,700…0,724
0,725…0,749		0,650
0,675
0,700
0,750…0,774
0,775…0,799
0,800…0,824		0,725
0,750
0,775
0,825…0,849
0,850…0,874
0,875…0,899		0,800
0,825
0,850
0,900…0,924
0,925…0,949
0,950…0,974		0,875
0,900
0,925
0,975…0,999
1,000…1,024
1,025…1,049		0,950
0,975
1,000
1,050…1,074
1,075…1,099
1,100…1,124		1,025
1,050
1,075
1,125…1,149
1,150…1,174
1,175…1,199		1,100
1,125
1,150
1,200…1,224
1,225…1,249
1,250…1,274		1,175
1,200
1,225
1,275…1,229
1,300…1,324
1,325…1,349		1,250
1,275
1,300
1,350…1,374
1,375…1,399
1,400…1,424		1,325
1,350
1,375
1,425…1,449
1,450…1,474
1,475…1,499		1,400
1,425
1,450
1,500…1,524
1,525…1,549
1,550…1,574		1,475
1,500
1,525
1,575…1,599
1,600…1,624
1,625…1,649		1,550
1,575
1,600
1,650…1,674
1,675…1,699
1,700…1,724		1,625
1,650
1,675

  Note
Assign the adjusting washers via the → Electronic Catalogue of Original Parts.
   
–  Remove drive shaft and press out outer ring/tapered-roller bearing from the gearbox housing with thrust washer -MP3-456 (VW 447 I)-.
–  Determine the adjusting washer thickness from the table → Anchor (example 1.175 mm).
  S35-0057
–  Press outer ring/tapered-roller bearing with thrust washer -MP3-413 (VW 510)- into the gearbox housing together with the adjusting washer (in the example 1.175 mm).
–  Position the gearbox housing and tighten screw to the given tightening torque → Chapter.
  S35-0058

Control measurement > < Setting drive shaft