skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Repairing shift mechanism > < Electric/electronic components and fitting locations (Octavia II, Superb II)

Octavia Mk2

Removing and installing automatic gearbox control unitJ217 (Octavia II, Superb II)
Removing and installing automatic gearbox control unit -J217- (Octavia II, Superb II)
Fitting location: The control unit is located in the front left wheelhouse.
Removing the control unit
–  Remove front wheel on the left.
–  Remove the left wheelhouse liner → Body Work; Rep. gr.66.
   
–  Unlock the plug connection from the gearbox control unit.
–  Screw out the screws.
–  Take out control unit.
  Note
The adaptation values in the gearbox control unit are reset when the plug connection of the gearbox control unit is separated. The control unit must re-initialise these values after re-start. During this „initialisation“ the gearshift quality can be worse than usual.
Install
–  Installation is carried out in the reverse order.
  S37-0202

Repairing shift mechanism > < Electric/electronic components and fitting locations (Octavia II, Superb II)