skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing clutch make "Sachs" > < Repairing clutch

Octavia Mk2

Summary of components - Repairing the clutch make „Sachs“
Summary of components - Repairing the clutch make „Sachs“
  Note
t  Observe the fault finding of the power transmission before replacing the clutch disc and the pressure plate - problems with the clutch and clutch control → Chapter.
t  Replace the clutch discs and pressure plates if the riveting is damaged or loose.
t  Assign the clutch disc and pressure plate in accordance with the engine identification characters via the → Electronic catalogue of original parts.
t  The two-mass flywheel, pressure plate and clutch disc are assigned to each other and must not be installed together with components from other manufacturers.
   
1 - The two-mass flywheel
q   make sure the centering pins are correctly fitted
q   The locating face for the clutch lining must be free from grooves, oil and grease
q   Observe removal instructions for two-mass flywheel → Engine; Rep. gr.13
q   Removing and Installing → Engine; Rep. gr.13
2 - Clutch disc
q   Assignment → Electronic Catalogue of Original Parts
q   removing and installing → Chapter
q   must only be replaced together with pressure plate
q   Fitting position → Fig.
3 - Pressure plate
q   Assignment → Electronic Catalogue of Original Parts
q   with resetting mechanism
q   Distinguishing feature → Fig.
q   removing and installing → Chapter
q   Check the extremities of the membrane springs → Fig.
q   Check feather joints and riveted joints → Fig.
q   must be replaced together with clutch disc
4 - Screw M6-13 Nm; screw M7-20 Nm
q   Assignment → Electronic Catalogue of Original Parts
q   Uniformly loosen crosswise and tighten

   

Removing and installing clutch make "Sachs" > < Repairing clutch