–
| Before installing the gearbox press the clutch release lever towards the gearbox housing and secure with mounting bolt or screw M 8 x 35. |
–
| After installing the gearbox release screw again. The hole is then closed with the 3rd fixing screw for the cable support/control cables. |
Note t
| Clean splines of drive shaft and apply a thin film of grease -G 000 100 -. |
t
| If the gearbox is replaced, ensure the intermediate plate between the engine and gearbox is correctly installed. |
t
| Check whether the dowel sleeves for centering the gearbox are present in the cylinder block, insert if necessary. |
Note
|
|
|