The installation of the gearbox occurs in reverse order. Observe the stress-free assembly bracket in the vehicle → Engine; Rep. gr.10. |
–
| After installing, check gear oil level → Chapter. |
Note t
| Clean splines of drive shaft and apply a thin film of grease -G 000 100-. |
t
| Always replace the self-locking nuts and screws. |
t
| If the gearbox is replaced, ensure the intermediate plate between the engine and gearbox is correctly installed. |
t
| Check whether the dowel sleeves for centering the gearbox are present in the cylinder block, insert if necessary. |
|
|
|