skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

Removing and installing gearbox (Octavia II, Superb II, Yeti) > < Install mechatronics for double clutch gearboxJ743; gearbox installed
Removing and installing the gearbox
Removing and installing the gearbox
Remove and install gearbox (Octavia II, Superb II, Yeti) → Chapter.
Tightening torques (Octavia II, Superb II, Yeti) → Chapter.
Remove and install gearbox (Fabia II, Roomster) → Chapter.
Tightening torques (Fabia II, Roomster) → Chapter.
  Note
t  Observe instructions for automatic gearbox DSG - 0AM → Chapter.
t  General repair information → Chapter.
t  All cable straps which are detached or cut open when removing, should be fitted on again in the same place when installing.
t  If the battery earth strap is disconnected and connected, carry out additional operations → Electrical System; Rep. gr.27.
   
t  Gearbox with different output shafts:
t  -A- up to 11.08 - rigid shaft
t  -B- as of 11.08 - flange shaft
  N39-10428

Removing and installing gearbox (Octavia II, Superb II, Yeti) > < Install mechatronics for double clutch gearboxJ743; gearbox installed