Octavia Mk2
| Removing and installing the drive shaft, output shaft, differential gear and shift forks |
| 1 - | Differential gear |
| q | disassembling and assembling → Chapter |
| 2 - | Gearbox housing |
| q | repairing → Chapter |
| 3 - | Oil drain plug |
| q | Tightening torque → Chapter |
| q | different versions; assign via the → Electronic Catalogue of Original Parts |
| 4 - | Flange shaft with pressure spring |
| q | removing and installing → Chapter |
| q | complete → Chapter |
| 5 - | Conical screw, 25 Nm |
| 6 - | 5 Nm and torque a further 90° |
| q | self-locking |
| q | always replace → Electronic Catalogue of Original Parts |
| q | to secure the bearing support with grooved ball bearings for the drive and output shaft Pos. 16 |
| 7 - | 23 Nm |
| q | for gearshift mechanism Pos. 15 |
| q | self-locking |
| q | always replace → Electronic Catalogue of Original Parts |
| 8 - | O-ring |
| q | always replace → Electronic Catalogue of Original Parts |
| 9 - | Bearing pins |
| 10 - | 5 Nm and torque a further 90° |
| q | always replace → Electronic Catalogue of Original Parts |
| 11 - | Gearshift shaft with cover |
| q | (Gearshift unit) |
| q | disassembling and assembling → Chapter |
| 12 - | 5 Nm and torque a further 90° |
| q | always replace → Electronic Catalogue of Original Parts |
| 13 - | Screw, 6 Nm |
| 14 - | Transmission neutral sender -G701- |
| q | on vehicles with start-stop system |
| 15 - | Reversing light switch -F4-, 20 Nm |
| 16 - | Sealing ring |
| q | if present, always replace → Electronic Catalogue of Original Parts |
| 17 - | Shift mechanism |
| q | Gearshift forks |
| q | disassembling and assembling → Chapter |
| 18 - | Drive shaft and output shaft with bearing support for grooved ball bearings |
| q | If the bearing support is released from the gearbox housing, it must always be replaced → Electronic Catalogue of Original Parts |
| q | pressing off and on bearing support → Chapter |
| q | Disassembling and assembling the drive shaft → Chapter |
| q | Disassembling and assembling the output shaft → Chapter |
| 19 - | Reverse shaft support |
| 20 - | Reverse gear |
| 21 - | 25 Nm and torque a further 90° |
| q | for reverse shaft support |
| q | always replace → Electronic Catalogue of Original Parts |
| 22 - | Oil drip pan |
| 23 - | Magnet |
| 24 - | Oil guide part |
