skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Testing oil pressure and oil pressure switchF1 > < Removing

Octavia Mk2

Install
Install
   
l  One of the four driver polygonal cams -arrow- on the crankshaft is located at the top.
  S17-0132
–  Position the assembly device -T10022- on the crankshaft and tighten the Allan screw of the inserting device -MP 1-207- by hand.
–  Insert new seal on the dowel sleeves -A-.
  S17-0052
–  Position the marking -arrow A- of the inside rotor of the oil pump to the marking for the fitting position -arrow B- of the oil pump housing cover.
–  Coat the polygonal cam of the crankshaft with oil.
–  Lightly oil the gasket ring of the oil pump.
–  Carefully push the oil pump onto the driver polygon cam of the crankshaft.
–  If necessary align the pump rotor with the driver polygonal cam of the crankshaft by turning slightly.
–  Subsequently, carefully slide the oil pump over the dowel sleeves.
–  Tighten the oil pump with new screws. Tightening torque: 12 Nm.
–  Remove assembly device -T10022-.
The further assembly is carried out in reverse order to disassembly.
  S17-0131

Testing oil pressure and oil pressure switchF1 > < Removing