Lever out the cap ( → Chapter, Pos. 4) with a screwdriver.
–
Unscrew the fixing screw ( → Chapter, position 3).
–
Push the release tool -T10238 - (for right-hand drive vehicles release tool -T10240 -) as shown up to the stop into the provided openings and remove the accelerator pedal module.
–
Disconnect connector at accelerator pedal module → Chapter.
Install
–
Fit the connector -2- onto the accelerator pedal module -5- → Chapter.
–
Push accelerator pedal module onto the retaining bolts -6-.
–
Insert the centering pin -7- into the hole on the underbody.
–
Fasten accelerator pedal module with screw -3- (10 Nm) and fit on cap -4-.