skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing engine support > < Checking the assembly bracket

Octavia Mk2

Adjusting the unit mounting
Adjusting the unit mounting
Precondition
   
l  Engine with gearbox supported with supporting device -T30099-, base -T30099/1- and adapter -MP9-200/3- or engine with gearbox supported with engine mount and engine/gearbox jack.
  S10-0402
The following dimensions -a- and -x- must be maintained:
l  Between engine bracket and engine support there must be a distance -a- = 10 mm.
l  The cast iron edge on the engine support -2- must be parallel to the supporting arm -1- the dimension -x- must be the same at the front and rear.
  Note
The distance -a- = 10 mm can be checked e.g. with suitable round bars.
Tightening torques of assembly bracket:
t  Octavia II → Chapter.
t  Yeti → Chapter.
  S10-0375

Removing and installing engine support > < Checking the assembly bracket