skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing engine > < Removing and installing engine

Octavia Mk2

Removing and installing engine trim panel
Removing and installing engine trim panel
  Caution
The brackets of the engine cover on the cylinder head cover can break off when they are incorrectly removed.
It is therefore necessary to remove the engine cover according to the following instruction.
   
–  Successively slacken the engine cover in the marked sequence -1 ... 4- from the fixing points. To do so, grip the engine cover from underneath as far as possible in the area of the -arrows- and pull it upwards out of the attachment.
Install
  Caution
Before installing the engine cover, check the correct fitting position of the 4 fixing elements (ball sockets), if necessary move them into the correct position. Otherwise this can lead to damage to the engine cover.
  N10-10354
–  If necessary, press the ball sockets of the engine cover into the correct position.
–  Position the engine cover onto the fixing points and press it in at the corners until it clicks into place.
  N10-10274

Removing engine > < Removing and installing engine