Octavia Mk2
Note
| 1 - | Valve |
| q | do not rework, only grinding in is permissible |
| q | mark the fitting position for re-installation |
| q | Valve dimensions → Chapter |
| q | inspecting valve guides → Chapter |
| 2 - | Cylinder head |
| q | pay attention to the notes → Chapter |
| q | check for distortion → Fig. |
| q | removing and installing: |
| t | Fabia II, Roomster, Rapid → Chapter |
| t | Octavia II, Superb II, Yeti → Chapter |
| q | after replacing fill entire system with fresh coolant |
| 3 - | Valve stem seal |
| q | replace → Chapter |
| 4 - | Valve spring |
| 5 - | Valve spring retainer |
| 6 - | Valve collets |
| 7 - | Screw cap |
| q | replace |
| q | removing: plunge into the installed bearing frame using a screwdriver and lever out |
| q | installing: drive in without sealant using a suitable thrust piece until flush |
| 8 - | Sealing ring |
| q | Do not additionally lubricate or grease sealing lip of the gasket ring |
| q | Remove oil residue on the camshaft stud with a clean cloth |
| q | before fitting, cover slot on the camshaft cone with adhesive tape (e.g. Scotch tape) |
| q | removing and installing → Chapter |
| 9 - | Exhaust camshaft |
| q | pay attention to different versions according to production date - part number |
| q | removing and installing → Chapter |
| q | Measure axial play → Chapter |
| 10 - | 10 Nm |
| q | order of tightening → Chapter |
| 11 - | Bearing frame |
| q | pay attention to sequence for loosening and tightening → Chapter |
| q | seal with silicone sealant -D 176 501 A1- |
| 12 - | Inlet camshaft |
| q | removing and installing → Chapter |
| q | Measure axial play → Chapter |
| 13 - | Roller rocker arm |
| q | Mark installation position |
| q | do not interchange |
| q | Check smooth operation of cylindrical-roller bearings |
| q | oil contact surfaces |
| 14 - | Locking clip |
| q | check for firm seating |
| 15 - | Hydraulic balancing element |
| q | Mark installation position |
| q | oil the contact surfaces before installing |
