skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Disconnect connector for accelerator pedal module and fit on > < Accelerator pedal module - Summary of components

Octavia Mk2

Removing and installing accelerator pedal module
Removing and installing accelerator pedal module
(Octavia II, Superb II, Yeti)
Special tools and workshop equipment required
t  Release tool -T10238- (for left-hand drive vehicle)
t  Release tool -T10240- (for right-hand drive vehicle)
Removing
   
–  Remove steering column cover -arrows-.
–  Disconnect connector from accelerator pedal module.
   To do so press down securing element at plug.
–  Lever out the cap with a screwdriver → Chapter.
–  Release fixing screw → Chapter.
  S20-0134
–  Push the release tool -T10238- (on right-hand drive vehicles release tool -T10240-) as shown up to the stop into the provided openings and remove the accelerator pedal module.
Install
  S20-0175
–  Fit the plug -2- onto the accelerator pedal module -5-.
   The locking of the connector must be audible.
–  Push again rubber grommet -1- onto the connector -2-.
–  Push accelerator pedal module onto the fixing bolts -6-.
–  Insert centering pin -7- in the hole in the vehicle floor.
–  Fasten accelerator pedal module with screw -3- (10 Nm) and fit on cap -4-.
–  Install steering column cover.
–  If the accelerator pedal module was replaced on vehicles with automatic gearbox, the engine control unit must be adapted → Vehicle diagnostic tester.
  S20-0270

Disconnect connector for accelerator pedal module and fit on > < Accelerator pedal module - Summary of components