Skoda Workshop Service and Repair Manuals > Octavia Mk2 > Power unit | 1,2/63; 77 kW TSI engine | Engine cooling | Parts of cooling system engine side | Removing and installing belt pulley for coolant pump

Removing and installing belt pulley for coolant pump

Special tools and workshop equipment required

t	Wrench for the water pump and power-assisted steering -MP 1-308 (V.A.G 1590) -

Change wrench for the water pump and power-assisted steering -MP 1-308-

–	Because of modified fixing screws for the belt pulley of the coolant pump, these three curvatures must be filed open.

-a- at least 1 mm

Removing

–	Remove V-ribbed belt → Chapter.

–	Release screws -arrows- and remove holder from timing case.

Note

The bracket at the timing case only serves as transport security of the engine before the first installation and must not be refitted.

–	Release the screws for the belt pulley for coolant pump, to do so counterhold with wrench for the water pump and power-assisted steering -V.A.G 1590 -.

Install

Installation is performed in the reverse order, pay attention to the following points:

t	Tightening torque: 20 Nm

Skoda Workshop Service and Repair Manuals