skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Engine cylinder head, valve gear > < Inspect piston, piston rings and cylinder bore

Octavia Mk2

Separating new conrod
Separating new conrod
It can happen that the predetermined breaking point on the new conrod is not completely pierced. If the conrod bearing cap cannot be removed by hand, then proceed as follows:
–  Mark the assignment of the conrod to the cylinder.
   
–  Slightly clamp the conrod in a vice provided with aluminium protective jaws, as shown in the illustration.
  Note
t  Only tension the conrod slightly in order to avoid damage on the conrod.
t  The conrod is clamped below the broken line.
–  Unscrew both screws -arrows- by approx. 5 turns.
  N13-10285
–  Carefully knock against the conrod bearing cap with a rubber hammer in -direction of arrow- in order to loosen it.
  N13-10286

Engine cylinder head, valve gear > < Inspect piston, piston rings and cylinder bore