skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing crankshaft-belt pulley > < Removing and installing flywheel

Octavia Mk2

Replacing crankshaft seal on belt pulley side
Replacing crankshaft seal on belt pulley side
Special tools and workshop equipment required
t  Gasket ring extractor -T30015 (3240)-
t  Assembly device -T10417-
t  Cap -T30003 (3161)-
Removing
–  Remove V-ribbed belt → Chapter.
–  Rotate the crankshaft in direction of rotation of engine on TDC for cylinder 1 → Chapter.
–  Remove crankshaft-belt pulley → Chapter.
   
–  Push the adapter piece -3161- into the gasket ring extractor -3240-.
–  Unscrew the inner part of the gasket ring extractor -3240- up to the beginning of the thread and lock with the knurled screw.
  N13-10401
–  Oil the thread head of the gasket ring extractor, position and apply pressure when screwing it into the gasket ring as far as possible.
–  Slacken knurled screw and turn inner side in -direction of arrow- against the crankshaft until the gasket ring is pulled out.
Install
  N13-10402
–  Position the sleeve -T10417/1- on the crankshaft stub and push the gasket ring over the sleeve.
–  Remove the sleeve -T10417/1- from the crankshaft stub.
  N13-10403
–  Press the gasket ring with the assembly device -T10417- by striking uniformly up to the stop in the timing case.
Install crankshaft belt pulley → Chapter.
Further installation occurs in a similar way in reverse order to removal.
  N13-10404

Removing and installing crankshaft-belt pulley > < Removing and installing flywheel