Skoda Workshop Service and Repair Manuals

Removing and installing bracket for top auxiliary units Removing Special tools and workshop equipment required t  Catch pan, e.g. -VAS 6208- t  Hose binding claw Removing –  Remove V-ribbed belt → Chapter. –  Remove alternator → Electrical System; Rep. gr.27. –  Drain the coolant from the cooling system → Chapter.

–  Remove lambda probe -G39--1-.

–  Release screws -arrows- and remove heat shield -1-.

–  Open the spring strap clamp -1- with the hose binding claw and detach the coolant hose.   Note When removing the oil feed line, make sure that the oil does not penetrate into the generator! Therefore, cover the generator with a clean cloth! –  Unscrew hollow screw -2- and fixing screw -3- and remove the oil feed line.

–  Unscrew fixing screws -1- and remove bracket. Install

–  Fit the bracket for auxiliary units to the cylinder block. –  Tighten fixing screws -1- to 25 Nm. –  Install oil feed line. Tightening torques:

Component	Nm
Fixing screw to exhaust turbocharger	8 Nm
Hollow screw (replace gasket rings)	20 Nm

–  Connect the coolant hose -1- and attach it to the engine oil cooler and remove the hose clamp -MP7-602 (3094)-. –  Top up and bleed cooling system → Chapter. –  Inspect coolant level in the coolant expansion reservoir, top up with coolant if necessary. –  Install alternator → Electrical System; Rep. gr.27. –  Install the V-ribbed belt → Chapter. Further installation occurs in a similar way in reverse order to removal.