Octavia Mk2
|
| 1 - | Lambda probe -G39-, 50 Nm |
| q | the thread of new lambda probes must be coated with assembly paste |
| q | for re-used lambda probe, only coat the thread with hot bolt paste -G 052 112 A3-; the paste must not get into the slots of the probe body |
| 2 - | 23 Nm |
| q | replace |
| q | Coat stud bolts of the turbocharger with hot bolt paste -G 052 112 A3-. |
| q | pay attention to mounting instructions and order for tightening → Fig. |
| 3 - | Catalytic converter with exhaust pipe |
| q | pay attention to mounting instructions and order for tightening → Fig. |
| 4 - | Gasket |
| q | replace |
| 5 - | Gasket |
| q | replace |
| 6 - | Intermediate pipe |
| 7 - | Clamping sleeve, 23 Nm |
| q | Tighten bolted connections evenly |
| 8 - | 25 Nm |
| q | replace |
| 9 - | Exhaust pipe |
| q | with decoupling element |
| q | do not twist decoupling element more than 10° - risk of damage |
| q | Secure the decoupling element against over-tensioning and bending by means of the transport security -T10403-. |
| 10 - | Hanger |
| 11 - | 25 Nm |
| 12 - | 25 Nm |
| q | replace |
| 13 - | Gasket |
| q | replace |
| 14 - | 25 Nm |
| q | replace |
| q | Coat pin screws of exhaust pipe with hot bolt paste -G 052 112 A3- |
| 15 - | 20 Nm |
| 16 - | Support |
| 17 - | Exhaust gas turbocharger |
| q | removing and installing → Chapter |
| q | The exhaust gas turbocharger with charge pressure regulator -V465- and exhaust manifold can only be replaced together |
| 18 - | Heat shield |
| 19 - | 10 Nm |
| q | first of all screw in all fixing screws by hand when installing |
| 20 - | Heat shield |
| 21 - | 10 Nm |
| 22 - | 10 Nm |
| 23 - | Lambda probe downstream of catalytic converter -G130-, 50 Nm |
| q | the thread of new lambda probes must be coated with assembly paste |
| q | for re-used lambda probe, only coat the thread with hot bolt paste -G 052 112 A3-; the paste must not get into the slots of the probe body |
| 24 - | 10 Nm |
| 25 - | 25 Nm |
| q | pay attention to mounting instructions and order for tightening → Fig. |
|
|
| Stage | Screws/nuts | Tightening torque |
| 1. | -Arrows- | Tighten nuts by hand up to contact surface. |
| 2. | -1- | 25 Nm |
| 3. | -2- | 25 Nm |
| 4. | -Arrows- | 23 Nm |
