Skoda Workshop Service and Repair Manuals > Octavia Mk2 > Power unit | 1,2/63; 77 kW TSI engine | Exhaust system | Removing and installing parts of the exhaust system

Replacing middle or rear silencer

Special tools and workshop equipment required

t	Body saw e.g. -V.A.G 1523 A -

t	Protective goggles

Note

t	For individually replacing the front or rear silencer, a separation point is provided in the connecting pipe.

t	The separation point is marked by indentations on the circumference of the exhaust pipe.

WARNING

In order to avoid injuries because of metal swarfs, wear safety goggles and safety clothing.

–	Separate exhaust pipe at right angles at the separation point -arrow 2- with body saw.

For the vehicles Fabia II, Roomster

For the vehicles Octavia II, Yeti

Continued for all vehicles

–	When installing, position clamping sleeve -4- at the side markings -arrow 1- and -arrow 3-.

–	Turn the clamping sleeve in such a way that the ends of the screws -arrow- do not protrude beyond the bottom edge of the clamping sleeve.

–	Align the rear silencer horizontally and tighten the clamping sleeve to 23 Nm.

–	Align exhaust system in cold condition free of stress → Chapter.

Skoda Workshop Service and Repair Manuals