Octavia Mk2
|
| 1 - | Oil pressure switch -F1- |
| q | in the left cylinder head |
| q | check → Chapter |
| 2 - | Solenoid valve for coolant circuit -N492- |
| 3 - | Solenoid valve 1 for activated charcoal filter -N80- |
| 4 - | Intake manifold pressure sender -G71- and intake air temperature sender -G42- |
| 5 - | Engine control unit -J623- |
| q | removing and installing → Chapter |
| 6 - | Control valve for fuel pressure -N276- |
| 7 - | Knock sensor 1 -G61- |
| q | at rear cylinder block |
| q | 20 Nm |
| 8 - | Hall sender -G40- |
| 9 - | Ignition transformer -N152- |
| t | D ignition transformer = ignition cable cyl. 1 |
| t | B ignition transformer = ignition cable cyl. 2 |
| t | C ignition transformer = ignition cable cyl. 3 |
| t | A ignition transformer = ignition cable cyl. 4 |
| 10 - | Injection valves |
| q | Injection valve for cylinder 1 -N30- |
| q | Injection valve for cylinder 2 -N31- |
| q | Injection valve for cylinder 3 -N32- |
| q | Injection valve for cylinder 4 -N33- |
| q | with Teflon gasket ring and supporting washer |
| q | after removing the injection valve, the Teflon gasket ring and the supporting washer must be replaced → Chapter |
| q | Remove and install injection valve → Chapter |
| 11 - | Charge pressure sender -G31- with intake air temperature sender 2 -G299- |
| 12 - | Throttle valve control unit -J338- |
| q | removing and installing → Chapter |
| q | clean → Chapter |
| q | in case of replacement, erase initialisation values and adapt the engine control unit -J623- → Vehicle diagnostic tester. |
| 13 - | Fuel pressure sender -G247- |
| q | check → Chapter |
| 14 - | Engine speed sender -G28- |
| q | removing and installing → Chapter |
| 15 - | Coolant temperature sender -G62- |
| 16 - | Coolant temperature sender at radiator outlet -G83- |
| 17 - | Charge pressure regulator -V465 - |
Note| The charge pressure regulator -V465- can only be replaced complete with exhaust gas turbocharger and exhaust manifold. |
| 18 - | Lambda probe downstream of catalytic converter -G130- and heater of lambda probe 1 downstream of catalytic converter -Z29- |
| 19 - | Spark plugs, 25 Nm |
| 20 - | lambda probe -G39- and heating for lambda probe -Z19- |
| 21 - | High pressure pump with fuel pressure regulating valve -N276- |
| q | removing and installing → Chapter |
