Check fuel pressure sender -G247- |
Special tools and workshop equipment required |
t
| Assembly device -T10118- |
t
| Open ring spanner with 3/8" drive, SW 27 mm |
t
| Pressure sensor tester, e.g. -VAS 6394- (includes digital manometer -VAS 6394/1-) |
t
| Adapter, e.g. -VAS 6394/3- |
t
| Test adapter, e.g. -VAS 5570- |
WARNING The injection system consists of a high pressure part (max. pressure of 12 MPa = 120 bar) and a low pressure part (pressure of approx. 0.6 MPa = 6 bar). |
Before opening the high pressure area, e.g. removing the high pressure pump, the fuel distributor, the injection valves, the fuel pipes or the fuel pressure sender -G247-, the fuel pressure in the high pressure area with a remaining pressure of approx. 0.6 MPa (6 bar) must be reduced. The procedure for this is described in the chapter „release pressure in the high pressure area of the fuel system“ → Chapter. |
|
–
| Disconnect plug -1- and remove fuel pressure sender -G247--2-. |
|
|
|