Skoda Workshop Service and Repair Manuals

Adjusting the unit mounting Special tools and workshop equipment required t  Supporting device -T30099- t  Surface -T30099/1- t  Adapter -MP9-200/3 (10-222A/3)- t  Lifting eye -10-222A/12- t  Snap hook –  Remove battery → Electrical System; Rep. gr.27. For vehicles with engine identification characters manufactured up to 12.2010 (exhaust emission standard EU-4) –  Remove liquefied petroleum gas control unit → Chapter. Continued for all vehicles –  Remove battery tray → Electrical System; Rep. gr.27.   Note

On LPG vehicles (engine identification characters CHGA) spacer washers of 4 mm thickness are fitted between the battery tray and the body below the front screws -bottom arrows-. –  Remove the cooling water tank cover → Body Work; Rep. gr.66.

–  Install supporting device -T30099- and support engine in fitting position. –  Uniformly pre-tension the engine/gearbox unit with both spindles, but do not raise.

–  Release the screws -arrows- of the assembly bracket at the engine.

–  Slightly loosen the screws -arrows- of the assembly bracket at the gearbox (less than 1 revolution). –  Successively replace all the screws (as long as it has not already been performed when installing the engine) and insert these loosely.

–  Move the engine/gearbox assembly with an assembly lever between engine support -1- and supporting arm -3- for engine mount until the following dimensions are set: l  Both bolt heads -2- must be positioned parallel to the edge of the supporting arm -3- for engine mount. l  Between engine bracket -1- and engine support -4- there must be a distance -x- = 10 mm.   Note The distance -x- can be checked e.g. with suitable round bars. –  Tighten the screws for the engine side assembly bracket → Chapter.

–  Make sure that on the gearbox side the edges of the supporting arm -2- and gearbox support -1- are parallel. l  Dimension -x- must be the same on both mount sides. –  Tighten the screws for the gearbox side assembly bracket → Chapter. Install Installation is performed in the reverse order, pay attention to the following points:   Note

On LPG vehicles (engine identification characters CHGA) spacer washers of 4 mm thickness are fitted between the battery tray and the body below the front screws -bottom arrows-.