skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing radiator > < Removing and installing coolant pump

Octavia Mk2

Removing and installing coolant regulator
Removing and installing coolant regulator
Special tools and workshop equipment required
t  Catch pan, e.g. -VAS 6208-
t  Pliers for spring strap clamps
  Note
Observe safety measures and rules for cleanliness when working on vehicles with liquefied petroleum gas system (LPG) → Chapter.
Removing
  WARNING
Observe measures when disconnecting the battery → Electrical System; Rep. gr.27.
–  Disconnect the battery-earth strap with the ignition off.
   
–  If present, remove engine cover -arrows-.
–  Drain coolant → Chapter.
  S10-0255
–  Detach coolant hoses -1- and -2-.
  S10-0266
–  Unscrew bolts -4-, take off connection fitting -3-, O-ring -2- and thermostat -1-.
Install
Installation is performed in a similar way in the reverse order. Pay attention to the following points:
  Note
Replace O-ring.
–  Clean sealing surface for O-ring or smoothen.
–  Insert coolant thermostat.
l  Fitting position:The clamp of the coolant thermostat must be positioned vertically.
–  Moisten new O-ring with coolant.
–  Connect up the battery. Important instructions → Electrical System; Rep. gr.27.
–  Top up coolant → Chapter.
  S19-0207

Removing and installing radiator > < Removing and installing coolant pump