skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing sealing flange and flywheel > < Installing (set the timing)

Octavia Mk2

Checking semi automatic toothed belt tensioning pulley
Checking semi automatic toothed belt tensioning pulley
  Note
Observe safety measures and rules for cleanliness when working on vehicles with liquefied petroleum gas system (LPG) → Chapter.
Test condition
l  Engine temperature should not exceed 40 °C.
Test sequence
–  Position engine on TDC cylinder 1.
   
–  Load timing belt by firmly pressing down with thumb -arrows-. The pointer -2- must move to the side.
–  Relieve the pressure on the toothed belt and rotate crankshaft a further two revolutions in direction of rotation of engine until the engine is again positioned at TDC of cylinder 1. When doing this, it is important that the last 45° (1/8 turn) are rotated without any interruption.
–  The tensioning roller must go back to its initial position. (The notch -1- and the pointer -2- are again standing opposite to each other.)
  Note
For the inspection use a mirror.
  S13-0107

Removing and installing sealing flange and flywheel > < Installing (set the timing)