skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing engine support > < Checking the assembly bracket

Octavia Mk2

Adjusting the unit mounting
Adjusting the unit mounting
Precondition
   
l  Engine with gearbox supported with supporting device -T30099-, base -T30099/1- and adapter -MP9-200/3- or engine with gearbox supported with engine mount and engine/gearbox jack -V.A.G 1383 A-.
  S10-0402
–  Slacken screws -arrows- of engine mount by approx. 1 turn.
  S10-0267
–  Slacken the screws of the gearbox mount at the gearbox 02Q -arrows- by approx. 1 turn.
–  Successively replace all the screws of the assembly bracket (as long as it has not already been performed when installing) and insert these loosely.
  S34-0875
The following dimensions -a- and -x- must be maintained:
l  Between engine bracket and engine support there must be a distance -a- = 10 mm.
l  The cast iron edge on the engine support -2- must be parallel to the supporting arm -1- the dimension -x- must be the same at the front and rear.
  Note
The distance -a- = 10 mm can be checked e.g. with suitable round bars.
–  Tighten the screws of the assembly bracket.
Tightening torques of the unit mounting → Chapter.
  S10-0375

Removing and installing engine support > < Checking the assembly bracket