skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing drive chain sprocket > < Removing and installing crankshaft

Octavia Mk2

Replace needle bearing for crankshaft
Replace needle bearing for crankshaft
(Octavia II, Superb II)
Only on vehicles fitted with automatic gearbox.
Special tools and workshop equipment required
t  Centering mandrel -T30029 (3176)-
t  Interior extractor -Kukko 21/2-
t  Countersupport -Kukko 22/1-
  Note
For installing an engine in a vehicle with automatic gearbox, check whether the needle bearing is built on the gearbox side in the crankshaft. Install the needle bearing as required.
Removing
   
–  Pull out needle bearing with interior extractor -Kukko 21/2- and countersupport -Kukko 22/1-.
Install
  A13-0227
–  Drive in the needle bearing using the centering pin -T30029-.
l  Fitting position: The marked side of the needle bearing should be legible when in its installed condition.
  S13-0332
Depth of installation of the needle bearing
l  Dimension -a-: 1.5 mm... 1.8 mm
  V13-0428

Removing and installing drive chain sprocket > < Removing and installing crankshaft